Maintenance and Tips

Lubricate Filter Seals: Hot Tub and Bath

The filter seals in your hot tub or Nordic bath can dry out. Lubricate them with silicone grease: where to find them and how to do it, step by step.

Retirer Brominateur Article   Horizontal
Difficulty level
Medium
Estimated time
5 min

Storvatt spas and Nordic baths share the same filter, equipped with two seals that ensure its tightness. Over time, these seals can dry out and cause leaks: lubricate them periodically with a thin layer of silicone grease. Here's where to find the filter seals and how to lubricate them step by step.

Why lubricate spa or Nordic bath filter seals

Storvatt wooden spas and Nordic baths use the same filter. It is equipped with two seals that ensure its tightness.

Over time, these seals can dry out and cause leaks. Periodic lubrication allows them to return to their original condition. This regular maintenance preserves optimal tightness, whether you have a spa or a bath.

Where are the two filter seals located

  • The first seal is located at the air purge plug, on top of the filter.

  • The second seal is located in the filter cover, under the collar.

How to lubricate filter seals

Silicone grease is sufficient for this maintenance, identical on a spa and on a Nordic bath.

How to Adjust the Sauna Door Latch

  1. Remove the air purge cap

    Unscrew the air purge cap at the top of the filter: the first seal is located at its level. Be careful not to lose this small seal.

    Petit Joint
  2. Unscrew the filter collar

    Unscrew the collar located above the cover to access the second seal.

    Devisser Collerette
  3. Remove the brominator cover

    Remove the cover by unscrewing it: the second seal is located in this cover, under the collar.

    Colerette

    Tip: Tip: when in place, the cover creates a suction effect; use back-and-forth movements rather than pulling vertically.

  4. Lubricate both seals

    Apply a thin layer of silicone grease to each of the two seals. This is enough to restore them to their original condition: there is no need to apply too much.

    Grand Joint 2

    Tip: Check the lubrication condition over time, without excess: there is no need to over-lubricate the seals. Light lubrication during major maintenance of your Storvatt is sufficient.

  5. Raise the filter

    Replace the cover on the filter, then screw the collar back on.

    Joints
  6. Purge and restart the system

    Open the valves, then purge the system: let the water out through the air vent before replacing and closing its cap. Then restart the system by restoring the power supply or exiting "HOLD" mode.

    Dévissez La Purge D'air (custom)

Need assistance with your sauna

Experiencing

FAQ

Is the Nordic bath filter the same as the hot tub filter?

Yes: Storvatt spas and Nordic baths are equipped with the same filter, with the same two seals. Maintenance is therefore identical.

What grease should be used for filter seals?

Use silicone grease. A thin layer is sufficient, there is no need to apply too much.

Can you use vaseline on the filter seals?

Ideally, use silicone grease. If not available, vaseline can be used in a thin layer.

How often should you lubricate filter seals?

Light lubrication during major maintenance of your Storvatt is sufficient. Check the lubrication condition over time, but there is no need to over-lubricate the seals.

What should I do if the filter seal is damaged?

If a seal is too damaged, grease will not be enough to restore the seal: it must be replaced. Contact our after-sales service for its replacement.

Read also

All posts